Pulsonix User Forum

Technical advice from Pulsonix engineers and the wider community.

 All Forums
 Help with using Pulsonix
 PCB Design
 Rats Nest and Templates

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List
   
Message:

* HTML is OFF
* Forum Code is ON

   Upload a file

Check here to subscribe to this topic.
   

T O P I C    R E V I E W
domgeb Posted - 16 Jan 2018 : 16:02:25
Hello,

I wanted to use templates as copper planes. So I created a plane, added it to the relevant net and poured the copper. The pads get connected as expected but the air wires remain visible.

Did I do anything wrong or do I need to update the ratsnest?


Best regards.
2   L A T E S T    R E P L I E S    (Newest First)
domgeb Posted - 17 Jan 2018 : 06:09:51
Hello Steve,

thank you very much; works like a charm.
Your assumption was correct; thank you for cerrecting my inaccurate phrase.

Best regards!
steve Posted - 16 Jan 2018 : 16:13:59
Run Optimise from Tools - Optimise Nets - All Nets. There are various options in Options that can be set to auto-optimise after certain functions are run.

I assume where you state "So I created a plane", you mean created the template on an Electrical layer, rather than created a template on a Power Plane layer!

Pulsonix Assistance